|
 Travel
heights form 25"to 84".
Capacities
from 500 lbs.to 12,000 lbs.
Standard
pump motors are 1/2 and 1 hp,115 Volt/60 Hz/1 phase
internal mounted.
Compact
design allows for maximum travel and capacity in minimum
space.
Standar
pump motor is a high torque totally enclosed motor with
stress proof shaft and all copper windings.
Motor
is closely coupled to heavy-duty gear pump with built-in
check and relief valves for reliable performance
and minimum maintenance.
115
Volt push button control or covered foot switch with
ten feet of power control cord is standard on all models.
Short
frame space saver models are designed for installation
in confined spaces.External pump unit is required
on all space saver models.
NOTE:
Capacities
are gross. Deduct any extra platform equipment fort
net capacity.
If
lift sits on floor,add lowered height to vertical travel
to determine total extended height.
Standard
down travel times are 10-20 secondes.
Optional
pump units are 1/2, 1, 11/2, 3, or 5 hp,230-460 V/50-60
Hz/3 phase with 115 Volt control transformer.Higher
hp than standard will increase raising speeds for a
shorter cycle time.For motors other than listed,consult
factory.
Certain
applications of hydraulic lifts have mandatory safely
requirements,consult factory for specific information.
Optional
manual or power travel available.
|
PRODUCTS 
